anbringen (動詞)

Description: Slimline Line 6 Profiles for fastening lightweight attachments. The ball latch plate is attached to the inside of the panel element. Attachments can be screw connected in all three spatial directions.

Description: Fastening Disc M5 is provided with a threaded blind hole. So it should not be used for profile connections in combination with fastening elements. For connecting profiles used as compressed air conduits, the Universal Fastener is also available in a special version (Section 6.2 Pneumatic Applications).

Description: The term fit describes the dimensional relationship between two parts that have the same Nominal dimension but have been produced to tolerances that differ in terms of position and size. Consequently, the term fit also describes the Tolerance within which the actual dimensions of a hole and Shaft, for example, can vary. The finished part will exhibit either a clearance fit (such as in sliding and guiding applications) or an interference fit, which is also referred to as a press fit (Friction Resistance in the case of shrink joints). If tolerances permit both interference and clearance, the fit is known as a transition fit, which can fall into one group or the other during production. A distinction is also made between Basic hole and Basic shaft fit systems.

Description: Mit zwei Fixierstücken wird die axiale Lage der Rolle festgelegt. Die axiale Lage der Rolle wird mit zwei Fixierstücken festgelegt. In fixed supports (valency of 3), the member is always tangentially adjacent.

Description: Processing the panel element for installing the Locking Systems. Simple aluminium conduits for installation of cables and hoses. Install the End Cap and Lubricating Systems on the bearing units.

Description: Place the pulley over the guide pin onto the mounting plate Its ball-bearing mounted pulleys ensure quiet and smooth running over long-term use. The latter allows users to mount the drive on the slide.